Show Span Session - Cisco MDS 9124 - Fabric Switch Reference

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

show span session

To display specific information about a SPAN session, use the show span session command.
Syntax Description
session-id
brief
Defaults None.
Command Modes EXEC mode
Command History Release
1.2(1)
3.3(1a)
Usage Guidelines None.
Examples The following example displays SPAN sessions in a brief format.
switch# show span session brief
--------------------------------------------------------
Session
--------------------------------------------------------
7
The following example displays specific SPAN session details.
switch# show span session 7
Session 7 (active)
Ingress (rx) sources are
fc1/5,
Egress (tx) sources are
fc1/5,
switch# show span session 7
Session 7 (active)
Ingress (rx) sources are
fc1/5,
Egress (tx) sources are
fc1/5,
OL-16217-01, Cisco MDS SAN-OS Release 3.x
show span session [session-id [brief] | brief]
Specifies the SPAN session ID. The range is 1 to 16.
Displays the SPAN session configuration in a brief format.
Modification
This command was introduced.
Added support for SPAN traffic in both ingress and egress directions.
Admin Oper
State State
no suspend active
Destination is fc2/7
No session filters configured
Destination is fc-tunnel 100
No session filters configured
Destination
Interface
fc2/7
Cisco MDS 9000 Family Command Reference
show span session
22-333