Fcip Profile - Cisco MDS 9124 - Fabric Switch Reference

Chapter 8 F Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

fcip profile

To create and configure an FCIP profile, use the fcip profile command. To remove an FCIP profile, use
the no form of the command.
Syntax Description
profile-id
Defaults None.
Command Modes Configuration mode.
Command History Release
1.1(1)
Usage Guidelines When you perform this command, the CLI enters FCIP profile configuration mode.
This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
Note
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following example shows how to configure an FCIP profile.
switch
switch(config)# fcip profile 5
switch(config-profile)#
Related Commands Command
show fcip profile
interface fcip
interface_number
use-profile profile-id
show interface fcip
OL-16217-01, Cisco MDS SAN-OS Release 3.x
fcip profile profile-id
no fcip profile profile-id
Specifies a ID range from 1 to 255.
Modification
This command was introduced.
#
# config terminal
Description
Displays information about the FCIP profile.
Configures the interface using an existing profile ID from 1 to 255.
Displays an interface configuration for a specified FCIP interface.
Cisco MDS 9000 Family Command Reference
fcip profile
8-35