Show Ipv6 Interface - Cisco MDS 9124 - Fabric Switch Reference

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

show ipv6 interface

To display IPv6 interface status and configuration information, use the show ipv6 interface command.
Syntax Description gigabitethernet slot/port Displays a Gigabit Ethernet interface.
mgmt 0
port-channel
port-channel-number
vsan
vsan-id
Defaults None.
Command Modes EXEC mode.
Command History Release
3.1(0)
Usage Guidelines None.
Examples The following example displaysIPv6 interface information.
switch# show ipv6 interface
GigabitEthernet1/2 is up
IPv6 is enabled
Global address(es):
Link-local address(es):
ND DAD is disabled
ND reachable time is 30000 milliseconds
ND retransmission time is 1000 milliseconds
Stateless autoconfig for addresses disabled
GigabitEthernet2/2 is up
IPv6 is enabled
Global address(es):
Link-local address(es):
ND DAD is disabled
ND reachable time is 30000 milliseconds
ND retransmission time is 1000 milliseconds
OL-16217-01, Cisco MDS SAN-OS Release 3.x
show ipv6 interface [gigabitethernet slot/port | mgmt 0 | port-channel port-channel-number |
vsan vsan-id]
Displays the management interface.
Displays a PortChannel interface.
Specifies the PortChannel number. The range is 1 to 128.
Displays an IPFC VSAN interface.
Specifies the VSAN ID. The range is 1 to 4093.
Modification
This command was introduced.
5000::1/64
fe80::205:30ff:fe01:a6bf
6000::1/64
fe80::205:30ff:fe00:a413
Cisco MDS 9000 Family Command Reference
show ipv6 interface
22-175