Iscsi Enable Module - Cisco MDS 9124 - Fabric Switch Reference

iscsi enable module

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
iscsi enable module
To enable iSCSI features for each IPS linecard to create corresponding iSCSI interfaces, use the iscsi
enable module command.
Syntax Description module-num
Defaults iSCSI interfaces are disabled on IPS linecards by default.
Command Modes Configuration mode.
Command History Release
3.2(1)
Usage Guidelines
None.
Examples The following example shows how to enable the iSCSI interface on a desired module number on the
switch.
switch# config
Enter configuration commands, one per line.
switch(config)# iscsi enable module 1
The iSCSI feature must be enabled before executing this command.
Note
Related Commands Command
iscsi enable
Cisco MDS 9000 Family Command Reference
11-88
iscsi enable module module-num
Specifies the desired IPS linecard module number on which iSCSI interfaces
need to be enabled.
Modification
This command was introduced.
Description
Enables the iSCSI features but does not create the interfaces.
End with CNTL/Z.
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands