Iscsi Initiator Idle-Timeout - Cisco MDS 9124 - Fabric Switch Reference

iscsi initiator idle-timeout

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
iscsi initiator idle-timeout
To configure the iSCSI initiator idle timeout, use the iscsi initiator idle-timeout command. To revert to
the default, use the no form of the command.
Syntax Description
seconds
Defaults 300 seconds.
Command Modes Configuration mode.
Command History Release
1.3
Usage Guidelines When the idle timeout value is set to 0, the initiator information is cleared immediately after the last
session from the initiator terminates.
This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
Note
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples
The following example configures the iSCSI initiator idle timeout to 180 seconds.
switch# config terminal
switch(config)# iscsi initiator idle-timeout 180
The following example reverts the default value of 300 seconds.
switch# config terminal
switch(config)# no iscsi initiator idle-timeout 240
Related Commands Command
show iscsi global
Cisco MDS 9000 Family Command Reference
11-90
iscsi initiator idle-timeout seconds
no iscsi initiator idle-timeout seconds
Specifies the timeout in seconds. The range is 0 to 3600.
Modification
This command was introduced.
Description
Displays global iSCSI configuration information.
Chapter 11
OL-16217-01, Cisco MDS SAN-OS Release 3.x
I Commands