Interface Gigabitethernet - Cisco MDS 9124 - Fabric Switch Reference

interface gigabitethernet

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
interface gigabitethernet
To configure an Gigabit Ethernet interface, use the interface gigabitethernet command. To revert to the
default values, use the no form of the command.
Syntax Description
slot/port
cdp enable
channel-group group-id
force
isns profile-name
Defaults Disabled.
Command Modes
Configuration mode.
Command History Release
1.0(3a)
1.1(1a)
1.3(1)
Usage Guidelines You can specify a range of interfaces by issuing a command with the following example format:
interface gigabitethernet1/1space-space2space,spacegigabitethernet3/1space-space2
Examples The following example configures the Gigabit Ethernet interface at slot 4 port 1.
switch# config terminal
switch(config)# interface gigabitethernet 4/1
switch(config-if)#
The following example enters a IP address and subnet mask for the selected Gigabit Ethernet interface.
switch(config-if)# ip address 10.1.1.100 255.255.255.0
Cisco MDS 9000 Family Command Reference
11-30
interface gigabitethernet slot/port
cdp enable
channel-group group-id [force]
isns profile-name
interface gigabitethernet slot/port
no cdp enable
no channel-group
no isns profile-name
Modification
This command was introduced.
Added the channel-group subcommand.
Added the isns subcommand.
Specifies a slot number and port number.
Enables Cisco Discovery Protocol (CDP) configuration parameters.
Adds to or removes from a PortChannel. The range is 1 to 128.
Forcefully adds a port.
Specifies the profile name to tag the interface. Maximum length is 64
characters.
Chapter 11
OL-16217-01, Cisco MDS SAN-OS Release 3.x
I Commands