Line Vty - Cisco MDS 9124 - Fabric Switch Reference

Chapter 14 L Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

line vty

To configure a virtual terminal line, use the line vty command. To negate the previously issued command
or to revert to factory defaults, use the no form of the command.
Syntax Description exec-timeout minutes
session-limit number
Defaults
None.
Command Modes Configuration mode.
Command History Release
1.0(2)
Usage Guidelines
The line vty command available in config t command mode. line vty configuration commands available
in config-line submode.
Examples The following example configures a virtual terminal line and sets the timeout for that line.
switch
switch(config)# line vty
switch(config-line)# exec-timeout 60
Related Commands Command
line console
line com1
OL-16217-01, Cisco MDS SAN-OS Release 3.x
line vty -->
exec-timeout minutes |
session-limit number
line vty -->
no exec-timeout |
no session-limit number
Configures timeout in minutes. The range is 0 to 525600. To disable, set to 0
minutes.
Configures the number of VSH sessions. The range is 1 to 64.
Modification
This command was introduced.
#
# config terminal
Description
Configure primary terminal line.
Confgiures the auxiliary COM 1 port
Cisco MDS 9000 Family Command Reference
line vty
14-9