Show Kernel Core - Cisco MDS 9124 - Fabric Switch Reference

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

show kernel core

To display kernel core configuration information, use the show kernel core command.
Syntax Description
limit
module slot
target
Defaults None.
Command Modes EXEC mode.
Command History Release
1.1(1)
Usage Guidelines None.
Examples The following examples display kernel core settings.
switch# show kernel core limit
2
switch# show kernel core target
10.50.5.5
switch# show kernel core module 5
module 5 core is enabled
OL-16217-01, Cisco MDS SAN-OS Release 3.x
show kernel core {limit | module slot | target}
Displays the configured line card limit.
Displays the kernel core configuration for a module in the specified slot.
Displays the configured target IP address.
Modification
This command was introduced.
level is header
dst_ip is 10.50.5.5
src_port is 6671
dst_port is 6666
dump_dev_name is eth1
dst_mac_addr is 00:00:0C:07:AC:01
Cisco MDS 9000 Family Command Reference
show kernel core
22-225