Cisco MDS 9124 - Fabric Switch Reference page 620

interface fcip
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
ficon
portnumber portnumber
hello-interval seconds
passive
retransmit-interval
passive-mode
peer-info
ipaddr ip-address
port number
qos
control control-value
data data-value
special-frame
peer-wwn pwwn-id
switchport
tcp-connections number
time-stamp
acceptable-diff number
use-profile profile-id
Defaults Disabled
Command Modes Configuration mode
Command History Release
1.1(1)
1.3(1)
2.0(x)
Usage Guidelines
You can specify a range of interfaces by issuing a command with the following example format:
interface fcip1space-space5space,spacefcip10space-space12space
Refer to the Cisco MDS 9000 Family CLI Configuration Guide for information on port number
allocation.
Cisco MDS 9000 Family Command Reference
11-28
Configures FICON parameters.
Configures the FICON port number for this interface.
Specifies FSPF hello-interval in seconds. The range is 1 to 65535.
Enables or disables FSPF on the interface.
Specifies FSPF retransmit interface in seconds. The range is 1 to
65535.
Configures a passive connection.
Configures the peer information.
Specifies the peer IP address.
Specifies the peer port number. The range is 1 to 65535.
Configures the differentiated services code point (DSCP) value to
mark all IP packets.
Specifies the control value for DSCP.
Specifies the data value for DSCP.
Configures special frames.
Specifies the peer WWN for special frames.
Configures switchport parameters.
Specifies the number of TCP connection attempts. Valid values are 1
or 2.
Configures time-stamp.
Specifies the acceptable time difference for time-stamps. The range is
1 to 60000.
Specifies the interface using an existing profile ID. The range is 1 to
255.
Modification
This command was introduced.
Added the ficon portnumber subcommand.
Added the qos subcommand.
Chapter 11
OL-16217-01, Cisco MDS SAN-OS Release 3.x
I Commands