Show Fc-Tunnel - Cisco MDS 9124 - Fabric Switch Reference

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

show fc-tunnel

To display configured Fibre Channel tunnel information, use the show fc-tunnel command.
Syntax Description
explicit-path
name
tunnel-id-map
Defaults None.
Command Modes EXEC mode.
Command History Release
1.2(1)
Usage Guidelines Multiple tunnel IDs can terminate at the same interface.
Examples The following example displays the FC tunnel status.
switch# show fc-tunnel
fc-tunnel is enabled
The following example displays the FC tunnel egress mapping information.
switch# show fc-tunnel tunnel-id-map
tunnel id egress interface
The following example displays explicit mapping information of the FC tunnel.
switch# show fc-tunnel explicit-path
Explicit path name: Alternate1
Explicit path name: User2
OL-16217-01, Cisco MDS SAN-OS Release 3.x
show fc-tunnel [explicit-path [name] | tunnel-id-map]
Modification
This command was introduced.
150 fc3/1
100 fc3/1
10.20.1.2 loose
10.20.1.3 strict
10.20.50.1 strict
10.20.50.4 loose
Displays all configured explicit paths.
Specifies the explicit path name. The maximum length is 16 characters.
Displays the mapping information for the outgoing interface.
Cisco MDS 9000 Family Command Reference
show fc-tunnel
22-69