Ip Name-Server - Cisco MDS 9124 - Fabric Switch Reference

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

ip name-server

To configure a name server, use the ip name-server command in configuration mode. To disable this
feature, use the no form of the command.
Syntax Description
ip-address
Defaults None.
Command Modes Configuration mode.
Command History Release
1.0(2)
Usage Guidelines You can configure a maximum of six servers. By default, no server is configured.
Examples The following example configure a name server with an IP address of 1.1.1.4.
switch# config terminal
switch(config)# ip name-server 1.1.1.4
The following example specifies the first address (15.1.0.1) as the primary server and the second address
(15.2.0.0) as the secondary sever.
switch(config)# ip name-server 15.1.0.1 15.2.0.0
The following example deletes the configured server(s) and reverts to factory default.
switch(config)# no ip name-server
Related Commands Command
show ip route
OL-16217-01, Cisco MDS SAN-OS Release 3.x
ip name-server ip-address
no ip name-server ip-address
Specifies the IP address for the name server.
Modification
This command was introduced.
Description
Displays the IP address of the default gateway.
Cisco MDS 9000 Family Command Reference
ip name-server
11-55