Cisco MDS 9124 - Fabric Switch Reference page 1351

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show scsi-target
To display information about existing SCSI target configurations, use the show scsi-target command.
Syntax Description
auto-poll
custom-list
devices
disk
lun
os
aix
all
hpux
linux
solaris
windows
vsan vsan-range
fcid fcid-id
status
tape
pwwn
Defaults None.
Command Modes
EXEC mode.
Command History Release
1.3(4)
Usage Guidelines Use the show scsi-target auto-poll command to verify automatic discovery of online SCSI targets.
Examples
The following example displays the status of a SCSI discovery.
switch# show scsi-target status
discovery completed
OL-16217-01, Cisco MDS SAN-OS Release 3.x
show scsi-target {auto-poll | custom-list | devices [vsan vsan-id] [fcid fcid-id] | disk [vsan
vsan-id] [fcid fcid-id] | lun [vsan vsan-id] [fcid fcid-id] [os [aix | all | hpux | linux | solaris |
windows] | pwwn | status | tape [vsan vsan-id] [fcid fcid-id]}
Displays SCSI target auto polling information.
Displays customized discovered targets.
Displays discovered scsi-target devices information
Displays discovered disk information.
Displays discovered SCSI target LUN information.
Discovers the specified operating system.
Specifies the AIX operating system.
Specifies all operating systems.
Specifies the HPUX operating system.
Specifies the Linux operating system.
Specifies the Solaris operating system.
Specifies the Windows operating system.
Specifies the VSAN ID or VSAN range. The ID range is 1 to 4093.
Specifies the FCID of the SCSI target to display.
Displays SCSI target discovery status.
Displays discovered tape information.
Displays discover pWWN information for each OS.
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
show scsi-target
22-319