Switchport Initiator Id - Cisco MDS 9124 - Fabric Switch Reference

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

switchport initiator id

To configure the iSCSI initiator ID mode, use the switchport initiator id command in interface
configuration submode. To delete the iSCSI inistiator ID mode, use the no form of the command.
Syntax Description
ip-address
name
Defaults The iSCSI initiator ID mode is disabled.
Command Modes Interface configuration submode under the iscsi interface x/x command.
Command History Release
1.1(1)
Usage Guidelines
None.
Examples The following example configures the iSCSI initiator ID mode for a iSCSI interface.
switch# config terminal
switch(config)# interface iscsi 2/5
switch(config-if)# switchport initiator id ip-address
switch(config-if)# switchport initiator name
Related Commands Command
show interface iscsi
OL-16217-01, Cisco MDS SAN-OS Release 3.x
switchport initiator id {ip-address | name}
no switchport initiator id {ip-address | name}
Identifies initiators using the IP address.
Identifies initiators using the specified name.
Modification
This command was introduced.
Description
Displays an interface configuration for a specified iSCSI interface.
Cisco MDS 9000 Family Command Reference
switchport initiator id
21-81