Fcflow Stats - Cisco MDS 9124 - Fabric Switch Reference

Cisco mds 9000 family command reference - cisco mds san-os release 3.0(1) through 3.3(1a) (ol-16217-01, april 2008)
Hide thumbs Also See for Cisco MDS 9124 - Fabric Switch:
Table of Contents

Advertisement

Chapter 8
F Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

fcflow stats

To configure fcflow statistics, use the fcflow stats command in configuration mode. To disable the
counter, use the no form of the command.
Syntax Description
aggregated
module
module-number
index flow-number
vsan vsan-id
destination-fcid
source-fcid
netmask
Defaults
None.
Command Modes
Configuration mode.
Command History
Release
1.0(2)
Usage Guidelines
If you enable flow counters, you can enable a maximum of 1K entries for aggregate flow and flow
statistics. Be sure to assign an unused flow index to a module for each new flow. Flow indexes can be
repeated across modules. The number space for flow index is shared between the aggregate flow
statistics and the flow statistics.
Examples
The following example shows how to configure aggregated fcflow statistics for module 1.
switch-config# fcflow stats aggregated module 1
switch-config#
The following example enables the aggregated flow counter.
switch(config)# fcflow stats aggregated module 1 index 1005 vsan 1
The following example disables the aggregated flow counter.
OL-16217-01, Cisco MDS SAN-OS Release 3.x
fcflow stats {aggregated module module-number index flow-number vsan vsan-id | module
module-number index flow-number destination-fcid source-fcid netmask vsan vsan-id}
no fcflow stats {aggregated module module-number index flow-number | module module-number
index flow-number}
Configures aggregated fcflow statistics.
Configure fcflow statistics on a module.
Specifies a flow index. The range is 1 to 2147483647.
Specifies a VSAN ID. The range is 1 to 4093.
Enters the destination FCID in hexadecimal format.
Enters the source FCID in hexadecimal format.
Enters the mask for the source and destination FCID (restricted to 6
hexadecimal characters ranging from 0xff0000 to 0xffffff).
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
fcflow stats
8-27

Advertisement

Table of Contents
loading

Table of Contents