Cisco MDS 9124 - Fabric Switch Reference page 1224

show iscsi virtual-target
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show iscsi virtual-target
To display all the iSCSI nodes that are local to the switch, use the show iscsi virtual-target command.
Syntax Description
configured
name
Defaults None.
Command Modes EXEC mode.
Command History Release
1.1(1)
Usage Guidelines If no parameter is provided the command lists all the active iSCSI virtual targets. If the iSCSI node name
is provided then the command lists the details of that iSCSI virtual target.
Examples
The following example displays information on all the iSCSI virtual targets.
switch# show iscsi virtual-target
target: abc1
target: iqn.com.domainname.172.22.93.143.08-03.gw.22000020374b5247
...
target: iqn.com.domainname.172.22.93.143.08-03.gw.210000203739aa39
The following example displays a specified iSCSI virtual target.
switch# show iscsi virtual-target
iqn.com.domainname.172.22.93.143.08-03.gw.210000203739a95b
target: iqn.com.domainname.172.22.93.143.08-03.gw.210000203739a95b
The following example displays the trespass status for a virtual target.
switch# show iscsi virtual-target iqn.abc
target: abc
Cisco MDS 9000 Family Command Reference
22-192
show iscsi virtual-target [configured] [name]
Show the information for all iSCSI ports.
Show iSCSI information for the specified virtual-target.
Modification
This command was introduced.
Port WWN 21:00:00:20:37:a6:b0:bf
Configured node
Port WWN 22:00:00:20:37:4b:52:47 , VSAN 1
Auto-created node
Port WWN 21:00:00:20:37:39:aa:39 , VSAN 1
Auto-created node
Port WWN 21:00:00:20:37:39:a9:5b , VSAN 1
Auto-created node
Port WWN 00:00:00:00:00:00:00:00
Configured node
all initiator permit is disabled
Chapter 22 Show Commands
OL-16217-01, Cisco MDS SAN-OS Release 3.x