Move - Cisco MDS 9124 - Fabric Switch Reference

Chapter 15 M Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
mutual-chap username (iSCSI initiator configuration and iSLB
initiator configuration)
To assign a username for the initiator's challenge, use the mutual-chap command in iSCSI initiator
configuration submode. To remove the username, use the no form of the command.
Syntax Description username username
password
0
7
password
Defaults None.
Command Modes
iSCSI initiator configuration submode.
iSLB initiator configuration submode.
Command History Release
2.0(1b)
3.0(1)
Usage Guidelines
The iSLB initiator can authenticate the Cisco MDS switch's initiator target during the iSCSI login phase.
This authentication requires the user to configure a username and password for the switch to present to
the iSLB initiator. The provided password is used to calculate a CHAP response to a CHAP challenge
sent to the IPS port by the initiator.
Examples The following example shows how to configure a username, password type, and password for an iSCSI
initiator challenge (mutual CHAP).
switch# config terminal
Enter configuration commands, one per line.
switch(config)# iscsi initiator name iqn.1987-02.com.cisco.initiator
switch(config-iscsi-init)# mutual-chap username userName password 0 cisco
switch(config-iscsi-init)#
OL-16217-01, Cisco MDS SAN-OS Release 3.x
mutual-chap username username password {0 cleartext-password | 7 encrypted-password |
password}
no mutual-chap username username password {0 cleartext-password | 7 encrypted-password |
password}
Specifies a username. The maximum size is 32.
Specifies a password for the initiator's challenge.
Specifies that the password is a cleartext CHAP password.
Specifies that the password is an encrypted CHAP password.
Specifies a password for the username. The maximum size is 32.
Modification
This command was introduced.
Added iSLB initiator configuration submode.
mutual-chap username (iSCSI initiator configuration and iSLB initiator configuration)
End with CNTL/Z.
Cisco MDS 9000 Family Command Reference
15-17