System Switchover (Configuration Mode) - Cisco MDS 9124 - Fabric Switch Reference

system switchover (configuration mode)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
system switchover (configuration mode)
To enable a switchover for the system, use the system switchover command in configuration mode. To
revert to the factory default setting, use the no form of the command.
Syntax Description
ha
warm
Defaults Disabled.
Command Modes Configuration mode.
Command History Release
1.3(1)
Usage Guidelines
None.
Examples The following example enables a HA switchover from an active supervisor module to a standby
supervisor module.
switch# config terminal
switch(config)# system switchover ha
Cisco MDS 9000 Family Command Reference
21-112
system switchover {ha | warm}
no system switchover
Specifies an HA switchover.
Specifies a warm switchover.
Modification
This command was introduced.
Chapter 21
OL-16217-01, Cisco MDS SAN-OS Release 3.x
S Commands