Time-Stamp - Cisco MDS 9124 - Fabric Switch Reference

Chapter 23 T Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

time-stamp

To enable FCIP time stamps on a frame, use the time-stamp command. To disable this command for the
selected interface, use the no form of the command.
Syntax Description
acceptable-diff number
Defaults Disabled.
Command Modes
Interface configuration submode.
Command History Release
1.1(1)
Usage Guidelines Access this command from the
The time-stamp option instructs the switch to discard frames that are older than a specified time.
Examples The following example enables the timestamp for an FCIP interface.
switch# config terminal
switch(config)# interface fcip 50
switch(config-if)# time-stamp
switch(config-if)# time-stamp acceptable-diff 4000
Related Commands Command
show interface fcip
OL-16217-01, Cisco MDS SAN-OS Release 3.x
time-stamp [acceptable-diff number]
no time-stamp [acceptable-diff number]
Configures the acceptable time difference for timestamps in milliseconds.
The range is 500 to 10000.
Modification
This command was introduced.
Description
Displays the configuration for a specified FCIP interface.
submode.
switch(config-if)#
Cisco MDS 9000 Family Command Reference
time-stamp
23-49