Vsan (Iscsi Initiator Configuration And Islb Initiator Configuration) - Cisco MDS 9124 - Fabric Switch Reference

Chapter 25 V Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
vsan (iSCSI initiator configuration and iSLB initiator
configuration)
To assign an iSCSI or iSLB initiator to a VSAN other than the default VSAN, use the vsan command in
iSCSI initiator configuration submode or iSLB initiator configuration submode. To disable this feature,
use the no form of the command.
Syntax Description vsan-id
Defaults None.
Command Modes
iSCSI initiator configuration submode.
iSLB initiator configuration submode.
Command History Release
1.3(2)
3.0(1)
Usage Guidelines
When you configure an iSLB initiator in a VSAN other than VSAN 1(the default VSAN), the initiator
is automatically removed from VSAN 1. For example, if you configure an iSLB initiator in VSAN 2 and
you also want it to be present in VSAN 1, you must explicitly configure the initiator in VSAN 1.
Examples
The following example assigns an iSCSI initiator to a VSAN other than the default VSAN.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# iscsi initiator name iqn.1987-02.com.cisco.initiator
switch(config-iscsi-init)# vsan 40
switch(config-iscsi-init)#
The following example assigns an iSLB initiator to a VSAN other than the default VSAN.
switch# config t
switch(config)# islb initiator ip-address 100.10.10.10
ips-hac2(config-islb-init)# vsan ?
<1-4093>
ips-hac2(config-islb-init)# vsan 10
The following example removes the iSLB initiator.
switch (config-islb-init)# no vsan 10
OL-16217-01, Cisco MDS SAN-OS Release 3.x
vsan vsan-id
no vsan vsan-id
Specifies a VSAN ID. The range 1 to 4093.
Modification
This command was introduced.
Added iSLB initiator configuration submode.
Enter VSAN

vsan (iSCSI initiator configuration and iSLB initiator configuration)

End with CNTL/Z.
Cisco MDS 9000 Family Command Reference
25-7