Cisco MDS 9124 - Fabric Switch Reference page 1498

username (iSCSI initiator configuration and iSLB initiator configuration)
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
username (iSCSI initiator configuration and iSLB initiator
configuration)
To assign a username for iSCSI login authentication, use the username command in iSCSI initiator
configuration submode. To assign a username for iSLB login authentication, use the username
command in iSLB initiator configuration submode.To disable this feature, use the no form of the
command.
Syntax Description username
Defaults
None.
Command Modes iSCSI initiator configuration submode.
iSLB initiator configuration submode.
Command History Release
1.3(2)
3.0(1)
Usage Guidelines None.
Examples The following example assigns the username for iSCSI login authentication of an iSCSI initiator.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# iscsi initiator name iqn.1987-02.com.cisco.initiator
switch(config-iscsi-init)# username iSCSIloginUsername
switch(config-iscsi-init)#
The following example assigns the username tester for iSLB login authentication of an iSLB initiator.
switch# config t
switch(config)# islb initiator ip-address 100.10.10.10
switch(config-iscsi-islb-init)# username ?
<WORD>
switch(config-iscsi-islb-init)# username tester
The following example removes the username tester for an iSLB initiator.
switch (config-iscsi-islb-init)# no username tester
Cisco MDS 9000 Family Command Reference
24-8
username username
no username username
Specifies the username for iSCSI or iSLB login authentication.
Modification
This command was introduced.
Added iSLB initiator configuration submode.
Enter username <Max Size - 32>
End with CNTL/Z.
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 24 U Commands