Show Zone Analysis - Cisco MDS 9124 - Fabric Switch Reference

show zone analysis

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 22-13
zoning database.
Table 22-13
Field
Active zoneset
Activated at
Activated from
Default zoning policy:
permit/deny
Cisco MDS 9000 Family Command Reference
22-394
describes the fields displayed in the output of a show zone analysis command for the active
show zone analysis Field Descriptions for the Active Zoning Database
Description
Displays the active zone set name. If a zone set has changed in the
full zoning database, an asterisk (*) appears after the zone set name.
If the active zone set is not present in the full zoning database, a
minus sign (-) appears after the zone set name.
Displays the time the zone set was activated.
Displays the agent that most recently modified the active zoning
database. The agent can be one of the following three types:
Local: indicates that the active database was last modified
•
locally through a configuration change from one of the
following applications:
Merge: indicates that the active database was last modified by
•
the Merge protocol. The interface on which the merge occurred
is also displayed.
Remote: indicates that the active database was last modified by
•
the Change protocol, initiated by a remote switch. The domain,
IP address, and switch name of the switch initiating the change
are also displayed.
Note
Displays the status of the default zoning policy for this VSAN.
CLI: The active zoning database was modified by the user
–
from the Command Line Interface.
SNMP: The active zoning database was modified by the
–
user through the Simple Network Management Protocol
(SNMP).
GS: The active zoning database was modified from the
–
Generic Services (GS) client.
CIM: The active zoning database was modified by the
–
applications using the Common Information Model (CIM).
INTERNAL: The active zoning database was modified as a
–
result of an internal activation either from Inter-VSAN
Routing (IVR) or from the IP Storage services manager.
The switch name is displayed on the next line, aligned with
the domain, only if the switch name is set. The default
switch name switch and the ip-address are not displayed.
Chapter 22 Show Commands
OL-16217-01, Cisco MDS SAN-OS Release 3.x