Show Rmon - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

show rmon

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show rmon
To display the remote monitoring (RMON) configuration or onboard log, use the show rmon command.
Syntax Description
alarms
events
hcalarms
logs
Defaults
None.
Command Modes EXEC mode
Command History Release
2.0(x)
2.1(2)
3.0(1)
Usage Guidelines None.
Examples
The following example displays the configured RMON alarms.
switch# show rmon alarms
Alarm 20 is active, owned by test
Monitors 1.3.6.1.2.1.2.2.1.16.30 every 30 second(s)
Taking delta samples, last value was 17
Rising threshold is 15, assigned to event 1
Falling threshold is 0, assigned to event 0
On startup enable rising or falling alarm
The following example displays the configured RMON events.
switch# show rmon events
Event 4 is active, owned by administrator@london_op_center
Description is WARNING(4)
Event firing causes log and trap to community public, last fired 03:32:43
Cisco MDS 9000 Family Command Reference
22-342
show rmon {alarms | events | hcalarms | logs}
Displays the configured 32-bit RMON alarms.
Displays the configured RMON events.
Displays the configured 64-bit high-capacity (HC) RMON alarms.
Displays the RMON event logs.
Modification
This command was introduced.
Added the logs option.
Added the hcalarms option.
Chapter 22 Show Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x