Snmp Trap Configuration - Juniper NETWORK AND SECURITY MANAGER NSMXPRESS - QUICK START REV1 Quick Start Manual

NSMXpress Quick Start
30
Description—A brief description of the appliance.
Click Save.
4.

SNMP Trap Configuration

To configure SNMP trap conditions:
Select System Administration > SNMP Monitoring.
1.
Select the SNMP Traps tab, which is shown in Figure 34 on page 30.
2.
Figure 34: Configuring SNMP Traps
In the field, enter the IP address of the SNMP management server.
Manager IP
3.
Select from the following trap conditions:
4.
Disk space low
Enter the percentage of free disk space below which SNMP issues a trap.
Memory low
Enter the percentage of free memory below which SNMP issues a trap.
CPU high
Enter the percentage of CPU use over which SNMP issues a trap.
NSM start/stop
Admin Logon/Logoff
External IP unreachable
Enter the IP address of the required device.
Click Save.
5.
Copyright © 2010, Juniper Networks, Inc.