Ospfv3 Commands; Ipv6 Ospf; Ipv6 Ospf Area - NETGEAR ProSafe GSM7224P User Manual

traffic command. If you do not specify an interface, the counters for all IPv6 traffic
statistics reset to zero.
Format
clear ipv6 statistics [{<unit/slot/port> | loopback <loopback-id> |
tunnel <tunnel-id>}]
Mode
Privileged EXEC

OSPFv3 Commands

This section describes the commands you use to configure OSPFv3, which is a link-state
routing protocol that you use to route traffic within a network.

ipv6 ospf

This command enables OSPF on a router interface or loopback interface.
Default
disabled
Format
ipv6 ospf
Mode
Interface Config
no ipv6 ospf
This command disables OSPF on a router interface or loopback interface.
Format
no ipv6 ospf
Mode
Interface Config

ipv6 ospf area

This command sets the OSPF area to which the specified router interface belongs. The
<areaid> is an IPv6 address, formatted as a 4-digit dotted-decimal number or a decimal
value in the range of <0-4294967295>. The <areaid> uniquely identifies the area to which
the interface connects. Assigning an area id, which does not exist on an interface, causes the
area to be created with default values.
Format
ipv6 ospf area <areaid>
Mode
Interface Config
ProSafe Managed Switch
IPv6 Commands
376