Show Ipv6 Mld Groups - NETGEAR ProSafe GSM7224P User Manual

no ipv6 mld last-member-query-count
Use this command to reset the <last-member-query-count> parameter of the interface
to the default value.
Format
no ipv6 mld last-member-query-count
Mode
Interface Config

show ipv6 mld groups

Use this command to display information about multicast groups that MLD reported. The
information is displayed only when MLD is enabled on at least one interface. If MLD was not
enabled on even one interface, there is no group information to be displayed.
Format
show ipv6 mld groups {<unit/slot/port> | <group-address>}
Mode
• Privileged EXEC
• User EXEC
The following fields are displayed as a table when <unit/slot/port> is specified.
Field Description
Group Address
The address of the multicast group.
Interface
Interface through which the multicast group is reachable.
Up Time
Time elapsed in hours, minutes, and seconds since the multicast group has been known.
Expiry Time
Time left in hours, minutes, and seconds before the entry is removed from the MLD
membership table.
When <group-address> is specified, the following fields are displayed for each multicast
group and each interface.
Field Description
Interface
Interface through which the multicast group is reachable.
Group Address
The address of the multicast group.
Last Reporter
The IP Address of the source of the last membership report received for this multicast
group address on that interface.
Filter Mode
The filter mode of the multicast group on this interface. The values it can take are
include and exclude.
Version 1 Host
The time remaining until the router assumes there are no longer any MLD version-1
Timer
Hosts on the specified interface.
Group Compat
The compatibility mode of the multicast group on this interface. The values it can take are
Mode
MLDv1 and MLDv2.
ProSafe Managed Switch
IPv6 Multicast Commands
431