Ipv6 Address - NETGEAR ProSafe GSM7224P User Manual

no ipv6 enable
Use this command to disable IPv6 routing on an interface.
Format
no ipv6 enable
Mode
Interface Config

ipv6 address

Use this command to configure an IPv6 address on an interface, including tunnel and
loopback interfaces, and to enable IPv6 processing on this interface. You can assign multiple
globally reachable addresses to an interface by using this command. You do not need to
assign a link-local address by using this command since one is automatically created. The
<prefix> field consists of the bits of the address to be configured. The <prefix_length>
designates how many of the high-order contiguous bits of the address make up the prefix.
You can express IPv6 addresses in eight blocks. Also of note is that instead of a period, a
colon now separates each block. For simplification, leading zeros of each 16 bit block can be
omitted. One sequence of 16 bit blocks containing only zeros can be replaced with a double
colon "::", but not more than one at a time (otherwise it is no longer a unique representation).
• Dropping zeros:
• Local host:
0000:0000:0000:0000:0000:0000:0000:0001
• Any host:
0000:0000:0000:0000:0000:0000:0000:0000
The hexadecimal letters in the IPv6 addresses are not case-sensitive. An example of an IPv6
prefix and prefix length is
The optional [eui-64] field designates that IPv6 processing on the interfaces was enabled
using an EUI-64 interface ID in the low order 64 bits of the address. If you use this option, the
value of <prefix_length> must be 64 bits.
Format
ipv6 address <prefix>/<prefix_length> [eui64]
Mode
Interface Config
no ipv6 address
Use this command to remove all IPv6 addresses on an interface or specified IPv6 address.
The <prefix> parameter consists of the bits of the address to be configured. The
<prefix_length> designates how many of the high-order contiguous bits of the address
comprise the prefix. The optional [eui-64] field designates that IPv6 processing on the
interfaces was enabled using an EUI-64 interface ID in the low order 64 bits of the address.
If you do not supply any parameters, the command deletes all the IPv6 addresses on an
interface.
Format
no ipv6 address
Mode
Interface Config
ProSafe Managed Switch
3ffe:ffff:100:f101:0:0:0:1 becomes 3ffe:ffff:100:f101::1
3ffe:1::1234/64
[
<prefix>/<prefix_length>] [eui64]
IPv6 Commands
becomes
becomes
.
357
::1
::