Show Spanning-Tree - NETGEAR ProSafe GSM7224P User Manual

Format
spanning-tree bpduforwarding
Mode
Global Config
no spanning-tree bpduforwarding
This command will cause the STP BPDU packets received from the network to be dropped if
STP is disabled.
Format
no spanning-tree bpduforwarding
Mode
Global Config

show spanning-tree

This command displays spanning tree settings for the common and internal spanning tree.
The following details are displayed.
Format
show spanning-tree
Mode
• Privileged EXEC
• User EXEC
Term Definition
Bridge Priority
Specifies the bridge priority for the Common and Internal Spanning tree (CST). The value
lies between 0 and 61440. It is displayed in multiples of 4096.
Bridge Identifier The bridge identifier for the CST. It is made up using the bridge priority and the base
MAC address of the bridge.
Time Since
Time in seconds.
Topology
Change
Topology
Number of times changed.
Change Count
Topology
Boolean value of the Topology Change parameter for the switch indicating if a topology
Change
change is in progress on any port assigned to the common and internal spanning tree.
Designated
The bridge identifier of the root bridge. It is made up from the bridge priority and the base
Root
MAC address of the bridge.
Root Path Cost
Value of the Root Path Cost parameter for the common and internal spanning tree.
Root Port
Identifier of the port to access the Designated Root for the CST
Identifier
Root Port Max
Derived value.
Age
Root Port
Derived value.
Bridge Forward
Delay
Hello Time
Configured value of the parameter for the CST.
ProSafe Managed Switch
Switching Commands
56