Show Mac-Address-Table Static; Show Mac-Address-Table Staticfiltering - NETGEAR ProSafe GSM7224P User Manual

6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter
must identify a valid VLAN.
Format
macfilter addsrc all <macaddr> <vlanid>
Mode
Global Config
no macfilter addsrc all
This command removes all interfaces to the source filter set for the MAC filter with the MAC
address of <macaddr> and VLAN of <vlanid>. You must specify the <macaddr>
parameter as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The <vlanid> parameter must identify a valid VLAN.
Format
no macfilter addsrc all <macaddr> <vlanid>
Mode
Global Config

show mac-address-table static

This command displays the Static MAC Filtering information for all Static MAC Filters. If you
select <all>, all the Static MAC Filters in the system are displayed. If you supply a value for
<macaddr>, you must also enter a value for <vlanid>, and the system displays Static
MAC Filter information only for that MAC address and VLAN.
Format
show mac-address-table static {<macaddr> <vlanid> | all}
Mode
Privileged EXEC
Term Definition
MAC Address
The MAC Address of the static MAC filter entry.
VLAN ID
The VLAN ID of the static MAC filter entry.
Source Port(s)
The source port filter set's slot and port(s).
Note: Only multicast address filters will have destination port lists.

show mac-address-table staticfiltering

This command displays the Static Filtering entries in the Multicast Forwarding Database
(MFDB) table.
Format
show mac-address-table staticfiltering
Mode
Privileged EXEC
ProSafe Managed Switch
Switching Commands
139