NETGEAR ProSafe GSM7224P User Manual page 23

Format
switch <oldunit> renumber <newunit>
Mode
Global Config
movemanagement
This command moves the Primary Management Unit functionality from one switch to another.
The <fromunit> is the switch identifier on the current Primary Management Unit. The
<tounit> is the switch identifier on the new Primary Management Unit. Upon execution,
the entire stack (including all interfaces in the stack) is unconfigured and reconfigured with
the configuration on the new Primary Management Unit. After the reload is complete, all
stack management capability must be performed on the new Primary Management Unit. To
preserve the current configuration across a stack move, execute the copy
system:running-config nvram:startup-config (in Privileged EXEC) command
before performing the stack move. A stack move causes all routes and layer 2 addresses to
be lost. This command is executed on the Primary Management Unit. The system prompts
you to confirm the management move.
Note: The movemanagement command does not NSF (non-stop
forwarding). To move the management unit to the backup unit, use
initiate failover instead. For more information, see
failover
Format
movemanagement <fromunit> <tounit>
Mode
Stack Global Config
standby
Use this command to configure a unit as a Standby Management Unit (STBY).
Format
standby <unit number>
Mode
Stack Global Config
Note: The Standby Management Unit cannot be the current Management
Unit. The Standby unit should be a management-capable unit.
slot
This command configures a slot in the system. The <unit/slot> is the slot identifier of the
slot. The <cardindex> is the index into the database of the supported card types,
ProSafe Managed Switch
on page 32.
Stacking Commands
23
initiate