Show Ipv6 Pim Neighbor; Show Ipv6 Pim Interface - NETGEAR ProSafe GSM7224P User Manual

PIM Mode..................................... Dense
Data Threshold Rate (Kbps)................... 0
Register Rate-limit (Kbps)................... 0
Interface Interface Mode
--------- --------------
1/0/1 Enabled

show ipv6 pim neighbor

Use this command to display the PIM neighbor information for all interfaces or for the
specified interface.
Format
show ipv6 pim neighbor [<unit/slot/port>|vlan]
Modes
• Privileged EXEC
• User EXEC
Term Definition
Interface
Valid slot and port number separated by forward slashes.
Neighbor
The IP address of the neighbor on an interface.
Address
Up Time
The time since this neighbor has become active on this interface.
Expiry Time
The expiry time of the neighbor on this interface.
DR Priority
DR Priority configured on this interface (PM-SM only).
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 pim neighbor 0/1
Interface Neighbor
Address

show ipv6 pim interface

Use this command to display PIM configuration information for all interfaces or for the
specified interface. If no interface is specified, configuration of all interfaces is displayed.
Format
show ipv6 pim interface [<unit/slot/port>|vlan]
Modes
• Privileged EXEC
• User EXEC
Term Definition
Mode
Active PIM protocol.
Interface
Interface number.
ProSafe Managed Switch
Operational-Status
----------------
Non-Operational
Up Time Expiry Time
(hh:mm:ss) (hh:mm:ss)
IPv6 Multicast Commands
422