NETGEAR ProSafe GSM7224P User Manual page 367

Prosafe managed switch command line interface (cli) 9.0.2
Hide thumbs Also See for ProSafe GSM7224P:
Table of Contents

Advertisement

Term
Definition
Router
The frequency, in seconds, that router advertisements are sent.
Advertisement
Interval
Router
Shows whether the managed configuration flag is set (enabled) for router advertisements
Advertisement
on this interface.
Managed
Config Flag
Router
Shows whether the other configuration flag is set (enabled) for router advertisements on
Advertisement
this interface.
Other Config
Flag
Router
Shows whether router advertisements are suppressed (enabled) or sent (disabled).
Advertisement
Suppress Flag
IPv6
Shows whether ICMPv6 Destination Unreachable messages may be sent (enabled) or
Destination
not (disabled). For more information, see
Unreachables
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 interface 1/0/1
Routing Mode................................... Disabled
Administrative Mode............................ Enabled
IPv6 Routing Operational Mode.................. Disabled
Bandwidth...................................... 100000
Interface Maximum Transmit Unit................ 1500
Router Duplicate Address Detection Transmits... 1
Router Advertisement NS Interval............... 0
Router Advertisement Lifetime.................. 1800
Router Advertisement Reachable Time............ 0
Router Advertisement Interval.................. 600
Router Advertisement Managed Config Flag....... Disabled
Router Advertisement Other Config Flag......... Disabled
Router Advertisement Suppress Flag............. Disabled
IPv6 Destination Unreachables.................. Enabled
No IPv6 prefixes configured.
If an IPv6 prefix is configured on the interface, the following information also appears.
Term
Definition
IFPv6 Prefix is
The IPv6 prefix for the specified interface.
Preferred
The amount of time the advertised prefix is a preferred prefix.
Lifetime
Valid Lifetime
The amount of time the advertised prefix is valid.
Onlink Flag
Shows whether the onlink flag is set (enabled) in the prefix.
Autonomous
Shows whether the autonomous address-configuration flag (autoconfig) is set (enabled)
Flag
in the prefix.
ProSafe Managed Switch
ipv6 nd router-preference
IPv6 Commands
367
on page 363.
kbps

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents