Storm-Control Unicast Rate (Global); Storm-Control Flowcontrol - NETGEAR ProSafe GSM7224P User Manual

no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value and disables
unicast storm recovery for all interfaces.
Format
no storm-control unicast level
Mode
Global Config

storm-control unicast rate (Global)

Use this command to configure the unicast storm recovery threshold for all interfaces in
packets per second. If the mode is enabled, unicast storm recovery is active, and if the rate of
L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the
traffic is dropped. Therefore, the rate of unicast traffic is limited to the configured threshold.
Default
0
Format
storm-control unicast rate <0-14880000>
Mode
Global Config
no storm-control unicast rate
This command sets the multicast storm recovery threshold to the default value for an
interface and disables multicast storm recovery.
Format
no storm-control unicast rate
Mode
Global Config

storm-control flowcontrol

This command enables 802.3x flow control for the switch and only applies to full-duplex
mode ports.
Note: 802.3x flow control works by pausing a port when the port becomes
oversubscribed and dropping all traffic for small bursts of time during
the congestion condition. This can lead to high-priority and/or
network control traffic loss.
Default
disabled
Format
storm-control flowcontrol
Mode
Global Config
ProSafe Managed Switch
Switching Commands
116