Multicast - NETGEAR ProSafe GSM7224P User Manual

Table 45. RIP Log Message
Component Message
RIP
RIP : discard response from xxx via
unexpected interface
Table 46. DHCP6 Log Message
Component Message
DHCP6
relay_to_server: Cannot relay to relay
server intf xxx: not IPv6 enabled

Multicast

Table 47. Cache Log Messages
Component Message
Cache
Out of memory when creating entry.
Cache
Out of memory when creating cache.
Table 48. IGMP Log Messages
Component Message
IGMP
Error creating IGMP pipe
Error opening IGMP pipe
IGMP
Error creating IGMP data pipe
Error opening IGMP data pipe
IGMP
Error getting memory for source record
IGMP
Failed getting memory for new group
ProSafe Managed Switch
Cause
When RIP response is received with a
source address not matching the incoming
interface's subnet.
Cause
Relay is enabled but neither the outgoing
interface nor the server IP address is
specified.
Cause
When we run out of memory while creating
a new cache (MFC) entry
When we run out of memory while creating
the cache itself
Cause
When we fail to create / open IGMP pipe for
Mcast control messages
When we fail to create / open IGMP data
pipe for Mcast data messages
When we are unable to allocate memory for
a source record in the received IGMP V3
report
When we are unable to allocate memory for
a group record in the received IGMP
V3/V2/V1 report
Log Messages
683