Show Mvr Interface - NETGEAR ProSafe GSM7224P User Manual

The following table describes the output parameters.
Term
MVR Group IP
Status
Members
Example:
(switch)#show mvr members
MVR Group IP
------------------
224.1.1.1
(switch)#show mvr members 224.1.1.1
MVR Group IP
------------------
224.1.1.1

show mvr interface

This command displays the MVR-enabled interfaces configuration.
Format
show mvr interface [<interface-id > [members [vlan <vid>]] ]
Mode Privileged EXEC
The following table explains the output parameters.
Parameter
Port
Type
Status
Immediate Leave
Example:
(switch)#show mvr interface
Port Type
--------- ---------------
1/0/9 RECEIVER
ProSafe Managed Switch
Definition
MVR group multicast IP address.
The status of the specific MVR group. It can be active or inactive.
The list of ports that participates in the specified MVR group.
Status
---------------
INACTIVE
Status
---------------
INACTIVE
Description
Interface number
The MVR port type. It can be none, receiver, or source type.
The interface status. It consists of two characteristics:
• active or inactive indicates whether the port is forwarding.
• inVLAN or notInVLAN indicates whether the port is part of any VLAN.
The state of immediate mode. It can be enabled or disabled.
Status
---------------------
ACTIVE/inVLAN
Multicast VLAN Registration (MVR)
Members
---------------------
1/0/1, 1/0/2, 1/0/3
Members
---------------------
1/0/1, 1/0/2, 1/0/3
Immediate Leave
--------------------
DISABLED
228