Show Mldsnooping - NETGEAR ProSafe GSM7224P User Manual

no set mld mrouter interface
Use this command to disable the status of the interface as a statically configured multicast
router-attached interface.
Format
no set mld mrouter interface
Mode
Interface Config

show mldsnooping

Use this command to display MLD Snooping information. Configured information is displayed
whether or not MLD Snooping is enabled.
Format
show mldsnooping [unit/slot/port | vlanid]
Mode
Privileged EXEC
When the optional arguments
displays the following information.
Term Definition
Admin Mode
Indicates whether or not MLD Snooping is active on the switch.
Interfaces
Interfaces on which MLD Snooping is enabled.
Enabled for
MLD Snooping
MLD Control
Displays the number of MLD Control frames that are processed by the CPU.
Frame Count
VLANs Enabled
VLANs on which MLD Snooping is enabled.
for MLD
Snooping
When you specify the
Term Definition
MLD Snooping
Indicates whether MLD Snooping is active on the interface.
Admin Mode
Fast Leave
Indicates whether MLD Snooping Fast Leave is active on the VLAN.
Mode
Group
Shows the amount of time in seconds that a switch will wait for a report from a particular
Membership
group on a particular interface, which is participating in the VLAN, before deleting the
Interval
interface from the entry. This value may be configured.
Max Response
Displays the amount of time the switch waits after it sends a query on an interface,
Time
participating in the VLAN, because it did not receive a report for a particular group on that
interface. This value may be configured.
Multicast
Displays the amount of time to wait before removing an interface that is participating in
Router Present
the VLAN from the list of interfaces with multicast routers attached. The interface is
Expiration Time
removed if a query is not received. This value may be configured.
ProSafe Managed Switch
unit/slot/port
values, the following information displays.
unit/slot/port
Switching Commands
177
or are not used, the command
vlanid