Port Lacpmode; Port Lacpmode Enable All; Port-Channel Static - NETGEAR ProSafe GSM7224P User Manual

port-channel static

This command enables the static mode on a port-channel (LAG) interface. By default the
static mode for a new port-channel is disabled, which means the port-channel is dynamic.
However if the maximum number of allowable dynamic port-channels are already present in
the system, the static mode for a new port-channel enabled, which means the port-channel is
static.You can only use this command on port-channel interfaces.
Default
disabled
Format
port-channel static
Mode
Interface Config
no port-channel static
This command sets the static mode on a particular port-channel (LAG) interface to the default
value. This command will be executed only for interfaces of type port-channel (LAG).
Format
no port-channel static
Mode
Interface Config

port lacpmode

This command enables Link Aggregation Control Protocol (LACP) on a port.
Default
enabled
Format
port lacpmode
Mode
Interface Config
no port lacpmode
This command disables Link Aggregation Control Protocol (LACP) on a port.
Format
no port lacpmode
Mode
Interface Config

port lacpmode enable all

This command enables Link Aggregation Control Protocol (LACP) on all ports.
Format
port lacpmode enable all
Mode
Global Config
ProSafe Managed Switch
Switching Commands
127