Gvrp Commands; Show Garp - NETGEAR ProSafe GSM7224P User Manual

range from 200 to 6000 (centiseconds). The value 1000 centiseconds is 10 seconds. You can
use this command on all ports (Global Config mode) or a single port (Interface Config mode),
and it only has an effect only when GVRP is enabled.
Default
1000
Format
set garp timer leaveall <200-6000>
Mode
• Interface Config
• Global Config
no set garp timer leaveall
This command sets how frequently Leave All PDUs are generated the default and only has
an effect when GVRP is enabled.
Format
no set garp timer leaveall
Mode
• Interface Config
• Global Config

show garp

This command displays GARP information.
Format
show garp
Mode
• Privileged EXEC
• User EXEC
Term Definition
GMRP Admin Mode
The administrative mode of GARP Multicast Registration Protocol (GMRP) for the
system.
GVRP Admin Mode
The administrative mode of GARP VLAN Registration Protocol (GVRP) for the
system.

GVRP Commands

This section describes the commands you use to configure and view GARP VLAN
Registration Protocol (GVRP) information. GVRP-enabled switches exchange VLAN
configuration information, which allows GVRP to provide dynamic VLAN creation on trunk
ports and automatic VLAN pruning.
Note: If GVRP is disabled, the system does not forward GVRP messages.
ProSafe Managed Switch
Switching Commands
87