NETGEAR ProSafe GSM7224P User Manual page 682

Table 42. Routing Table Manager Log Messages
Component Message
Routing Table
RTO is full. Routing table contains 8000
Manager
best routes, 8000 total routes.
Routing Table
RTO no longer full. Bad adds: 10. Routing
Manager
table contains 7999 best routes, 7999 total
routes.
Table 43. VRRP Log Messages
Component Message
VRRP
Changing priority to 255 for virtual router
with VRID 1 on interface 1/0/1
VRRP
Changing priority to 100 for virtual router
with VRID 1 on interface 1/0/1
VRRP
vrrpPacketValidate: Invalid TTL
Table 44. ARP Log Message
Component Message
ARP
ARP received mapping for IP address xxx
to MAC address yyy. This IP address may
be configured on two stations.
ProSafe Managed Switch
Cause
The routing table manager, also called
"RTO," stores a limited number of best
routes, based on hardware capacity. When
the routing table becomes full, RTO logs
this alert. The count of total routes includes
alternate routes, which are not installed in
hardware.
When the number of best routes drops
below full capacity, RTO logs this notice.
The number of bad adds may give an
indication of the number of route adds that
failed while RTO was full, but a full routing
table is only one reason why this count is
incremented.
Cause
When the router is configured with the
address being used as the virtual router ID,
the router's priority is automatically set to
the maximum value to ensure that the
address owner becomes the VRRP master.
When the router is no longer the address
owner, Switch CLI reverts the router's
priority to the default.
VRRP ignored an incoming message
whose time to live (TTL) in the IP header
was not 255.
Cause
When we receive an ARP response with
different MAC address from another station
with the same IP address as ours. This
might be a case of misconfiguration.
Log Messages
682