NETGEAR ProSafe GSM7224P User Manual page 684

Table 49. IGMP-Proxy Log Messages
Component Message
IGMP-Proxy
Error getting memory for igmp host group
record
IGMP-Proxy
Error getting memory for source record
Table 50. PIM-SM Log Messages
Component Message
PIM-SM
PIM-SM not initialized
PIM-SM
Unable to take xxx semaphore
PIM-SM
Warning : Could not send packet type xxx
(pimsm packet type) on rtrIfNum
PIM-SM
add_kernel_cache : memory allocation
failed
PIM_SM
Config error. Trying to add static RP.
Dynamic RP with same ip addr exists
PIM-SM
Inner xxx(source/group) address of register
message is invalid
ProSafe Managed Switch
Cause
When we are unable to allocate memory for
the IGMP group record in the Host (Proxy)
table
When we are unable to allocate memory for
the IGMP source record in the Host (Proxy)
table
Cause
This message arises when trying to
activate pimsm interfaces or receiving
pimsm packets when pimsm component is
not initialized.
This message is logged when failed to
acquire semaphore to access source list or
group list or candidate Rp list or virtual
interface list. The xxx specifies the list for
which the access is denied.
this warning is logged when failed to send a
pimsm control packet on the specified
router interface.
This message is logged when there is
insufficient memory to add an mroute entry
into cache.
Router learns RP-group mapping through
Bootstrap messages received.This
message pops when the static RP is
configured which conflicts the mapping
learnt dynamically through Bootstrap
messages.
This log message appears when a register
message is received with invalid inner ip
source or group address.
Log Messages
684