Simple Network Time Protocol (Sntp) Commands; Write Memory; Sntp Broadcast Client Poll-Interval - NETGEAR ProSafe GSM7224P User Manual

Source
<url>
{image1 | image2}
image1
image2
{image1 | image2}
{image1 | image2}

write memory

Use this command to save running configuration changes to NVRAM so that the changes
you make will persist across a reboot. This command is the same as copy
system:running config nvram:startup-config.
Format
write memory
Mode
Privileged EXEC

Simple Network Time Protocol (SNTP) Commands

This section describes the commands you use to automatically configure the system time
and date by using SNTP.

sntp broadcast client poll-interval

This command sets the poll interval for SNTP broadcast clients in seconds as a power of two
where <poll-interval> can be a value from 6 to 10.
Default
6
Format
sntp broadcast client poll-interval <poll-interval>
Mode
Global Config
no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default value.
Format
no sntp broadcast client poll-interval
Mode
Global Config
ProSafe Managed Switch
Destination Description
{image1 | image2} Download an image from the remote server to either
image. In a stacking environment, the downloaded
image is distributed to the stack nodes.
<url> Upload either image to the remote server.
image2 Copy image1 to image2.
image1 Copy image2 to image1.
unit://<unit>/{image1 | Copy an image from the management node to a given
image2} node in a Stack. Use the unit parameter to specify the
node to which the image should be copied.
unit://*/{image1 | Copy an image from the management node to all of
image2} the nodes in a Stack.
Utility Commands
536