NETGEAR ProSafe GSM7224P User Manual page 545

default-router
This command specifies the default router list for a DHCP client. {address1, address2...
address8} are valid IP addresses, each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid.
Default
none
Format
default-router <address1> [<address2>....<address8>]
Mode
DHCP Pool Config
no default-router
This command removes the default router list.
Format
no default-router
Mode
DHCP Pool Config
dns-server
This command specifies the IP servers available to a DHCP client. Address parameters are
valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP address
0.0.0.0 is invalid.
Default
none
Format
dns-server <address1> [<address2>....<address8>]
Mode
DHCP Pool Config
no dns-server
This command removes the DNS Server list.
Format
no dns-server
Mode
DHCP Pool Config
hardware-address
This command specifies the hardware address of a DHCP client. Hardware-address is the
MAC address of the hardware platform of the client consisting of 6 bytes in dotted
hexadecimal format. Type indicates the protocol of the hardware platform. It is 1 for 10 MB
Ethernet and 6 for IEEE 802.
Default
ethernet
Format
hardware-address <hardwareaddress> <type>
Mode
DHCP Pool Config
ProSafe Managed Switch
Utility Commands
545