Show Arp; Clear Arp-Cache; Clear Arp-Switch - NETGEAR ProSafe GSM7224P User Manual

no arp timeout
This command configures the default ARP entry ageout time.
Format
no arp timeout
Mode
Global Config

clear arp-cache

This command causes all ARP entries of type dynamic to be removed from the ARP cache. If
the gateway keyword is specified, the dynamic entries of type gateway are purged as well.
Format
clear arp-cache [gateway]
Mode
Privileged EXEC

clear arp-switch

Use this command to clear the contents of the switch's Address Resolution Protocol (ARP)
table that contains entries learned through the Management port. To observe whether this
command is successful, ping from the remote system to the DUT. Issue the show arp
switch command to see the ARP entries. Then issue the clear arp-switch command
and check the show arp switch entries. There will be no more arp entries.
Format
clear arp-switch
Mode
Privileged EXEC

show arp

This command displays the Address Resolution Protocol (ARP) cache. The displayed results
are not the total ARP entries. To view the total ARP entries, the operator should view the
show arp results in conjunction with the show arp switch results.
Format
show arp
Mode
Privileged EXEC
Term Definition
Age Time
The time it takes for an ARP entry to age out. This is configurable. Age time is
(seconds)
measured in seconds.
Response Time
The time it takes for an ARP request timeout. This value is configurable. Response
(seconds)
time is measured in seconds.
Retries
The maximum number of times an ARP request is retried. This value is configurable.
Cache Size
The maximum number of entries in the ARP table. This value is configurable.
Dynamic Renew
Displays whether the ARP component automatically attempts to renew dynamic ARP
Mode
entries when they age out.
ProSafe Managed Switch
Routing Commands
235