Ipv6 Unreachables; Ipv6 Icmp Error-Interval - NETGEAR ProSafe GSM7224P User Manual

ipv6 nd router-preference
This command will set the router preference to default.
Format
no ipv6 router-preference
Mode
Interface Config

ipv6 unreachables

Use this command to enable the generation of ICMPv6 Destination Unreachable messages.
By default, the generation of ICMPv6 Destination Unreachable messages is enabled.
Default
enable
Format
ipv6 unreachables
Mode
Interface Config
no ipv6 unreachables
Use this command to prevent the generation of ICMPv6 Destination Unreachable messages.
Format
no ipv6 unreachables
Mode
Interface Config

ipv6 icmp error-interval

Use this command to limit the rate at which ICMPv6 error messages are sent. The rate limit is
configured as a token bucket, with two configurable parameters, burst-size and burst-interval.
The burst-interval specifies how often the token bucket is initialized with burst-size tokens.
burst-interval is from 0 to 2147483647 milliseconds (msec).
The burst-size is the number of ICMPv6 error messages that can be sent during one
burst-interval. The range is from 1 to 200 messages.
To disable ICMP rate limiting, set burst-interval to zero (0).
Default
• burst-interval of 1000 msec.
• burst-size of 100 messages
Format ipv6 icmp error-interval <burst-interval> [<burst-size>]
Mode
Global Config
ProSafe Managed Switch
IPv6 Commands
364