PoE Commands
poe
Use this command to enable the Power over Ethernet (PoE) functionality on a global basis or per
interface.
Format
poe
Mode
Global Config
Interface Config
Default
enabled
no poe
Use this command to disable the Power over Ethernet (PoE) functionality on a global basis or per
interface.
Format
no poe
Mode
Global Config
Interface Config
poe detection
Use this command to configure the detection type on a global basis or per interface. It is used to
configure which types of PDs will be detected and powered by the switch. There are three
options:
•
ieee—Detect resistive-type devices (IEEE standard)
•
pre-ieee—Legacy capacitive detection only (non-standard)
•
auto—Perform resistive detection first (IEEE standard), and then capacitive detection
(pre-IEEE standard)
Format
poe detection { ieee | pre-ieee | auto}
Mode
Global Config
Interface Config
Default
auto
ProSafe Managed Switch
Power over Ethernet (PoE) Commands
491