Show Ip Vrrp Interface Stats; No Ip Vrrp Vrid Accept-Mode - NETGEAR ProSafe GSM7224P User Manual

no ip vrrp vrid accept-mode

This command is used to allow a router to respond to ICMP Echo Requests sent to an
address on a VRRP virtual router.
Format
no ip vrrp <vrid> accept-mode
Mode
Interface Config

show ip vrrp interface stats

This command displays the statistical information about each virtual router configured on the
switch.
Format
show ip vrrp interface stats <unit/slot/port> <vrid>
Modes
• Privileged EXEC
• User EXEC
Term Definition
Uptime
The time that the virtual router has been up, in days, hours, minutes and seconds.
Protocol
The protocol configured on the interface.
State
The total number of times virtual router state has changed to MASTER.
Transitioned to
Master
Advertisement
The total number of VRRP advertisements received by this virtual router.
Received
Advertisement
The total number of VRRP advertisements received for which advertisement interval is
Interval Errors
different than the configured value for this virtual router.
Authentication
The total number of VRRP packets received that don't pass the authentication check.
Failure
IP TTL errors
The total number of VRRP packets received by the virtual router with IP TTL (time to live)
not equal to 255.
Zero Priority
The total number of VRRP packets received by virtual router with a priority of '0'.
Packets
Received
Zero Priority
The total number of VRRP packets sent by the virtual router with a priority of '0'.
Packets Sent
Invalid Type
The total number of VRRP packets received by the virtual router with invalid 'type' field.
Packets
Received
Address List
The total number of VRRP packets received for which address list does not match the
Errors
locally configured list for the virtual router.
Invalid
The total number of VRRP packets received with unknown authentication type.
Authentication
Type
ProSafe Managed Switch
Routing Commands
260