Show Sysinfo; Show Running-Config Interface; Show Tech-Support - NETGEAR ProSafe GSM7224P User Manual

• If all the flags in a particular group are enabled, then the command displays trapflags
<group name> all.
• If some, but not all, of the flags in that group are enabled, the command displays
trapflags <groupname> <flag-name>.
Format
show running-config [all | <scriptname> | changed]
Mode
Privileged EXEC

show running-config interface

This command shows the current configuration on a particular interface. The interface could
be a physical port or a virtual port—like a LAG or VLAN. The output captures how the
configuration differs from the factory default value.
Format
show running-config interface {<unit/slot/port>} | VLAN <id> | LAG <id>}
Mode
Interface Config

show sysinfo

This command displays switch information.
Format
show sysinfo
Mode
Privileged EXEC
Term Definition
Switch
Text used to identify this switch.
Description
System Name
Name used to identify the switch. The factory default is blank. To configure the system
name, see
System
Text used to identify the location of the switch. The factory default is blank. To configure
Location
the system location, see
System Contact
Text used to identify a contact person for this switch. The factory default is blank. To
configure the system location, see
System Object
The base object ID for the switch's enterprise MIB.
ID
System Up Time
The time in days, hours and minutes since the last switch reboot.
MIBs Supported
A list of MIBs supported by this agent.

show tech-support

Use the show tech-support command to display system and configuration information
when you contact technical support. The output of the show tech-support command
combines the output of the following commands:
ProSafe Managed Switch
snmp-server on page 628.
snmp-server
snmp-server
Utility Commands
514
on page 628.
on page 628.