NETGEAR ProSafe GSM7224P User Manual page 15

Table 5. CLI Command Modes (Continued)
Command Mode Prompt
Interface Config Switch (Interface <unit/slot/port>)#
Switch (Interface Loopback <id>)#
Switch (Interface Tunnel <id>)#
Line Config Switch (line)#
Policy Map Switch (Config-policy-map)#
Config
Policy Class Switch (Config-policy-class-map)#
Config
Class Map Config Switch (Config-class-map)#
Ipv6_Class-Map Switch (Config-class-map)#
Config
Router OSPF Switch (Config-router)#
Config
Router OSPFv3 Switch (Config rtr)#
Config
Router RIP Config Switch (Config-router)#
MAC Access-list Switch (Config-mac-access-list)#
Config
TACACS Config Switch (Tacacs)#
DHCP Pool Switch (Config dhcp-pool)#
Config
DHCPv6 Pool Switch (Config dhcp6-pool)#
Config
Stack Global Switch (Config stack)#
Config Mode
ARP Access-List Switch (Config-arp-access-list)#
Config Mode
ProSafe Managed Switch
Mode Description
Manages the operation of an interface and
provides access to the router interface
configuration commands.
Use this mode to set up a physical port for a
specific logical connection operation.
Contains commands to configure outbound
telnet settings and console interface settings.
Contains the QoS Policy-Map configuration
commands.
Consists of class creation, deletion, and
matching commands. The class match
commands specify Layer 2, Layer 3, and
general match criteria.
Contains the QoS class map configuration
commands for IPv4.
Contains the QoS class map configuration
commands for IPv6.
Contains the OSPF configuration commands.
Contains the OSPFv3 configuration commands.
Contains the RIP configuration commands.
Allows you to create a MAC Access-List and to
enter the mode containing MAC Access-List
configuration commands.
Contains commands to configure properties for
the TACACS servers.
Contains the DHCP server IP address pool
configuration commands.
Contains the DHCPv6 server IPv6 address pool
configuration commands.
Allows you to access the Stack Global Config
Mode.
Contains commands to add ARP ACL rules in
an ARP Access List.
Using the Command-Line Interface
15