Ip Arp Inspection Validate; Ip Arp Inspection Vlan Logging; Ip Arp Inspection Trust - NETGEAR ProSafe GSM7224P User Manual

ip arp inspection validate

Use this command to enable additional validation checks like source-mac validation,
destination-mac validation, and ip address validation on the received ARP packets. Each
command overrides the configuration of the previous command. For example, if a command
enables src-mac and dst-mac validations, and a second command enables IP validation only,
the src-mac and dst-mac validations are disabled as a result of the second command.
Default
disabled
Format
ip arp inspection validate {[src-mac] [dst-mac] [ip]}
Mode
Global Config
no ip arp inspection validate
Use this command to disable the additional validation checks on the received ARP packets.
Format
no ip arp inspection validate {[src-mac] [dst-mac] [ip]}
Mode
Global Config

ip arp inspection vlan logging

Use this command to enable logging of invalid ARP packets on a list of comma-separated
VLAN ranges.
Default
enabled
Format
ip arp inspection vlan vlan-list logging
Mode
Global Config
no ip arp inspection vlan logging
Use this command to disable logging of invalid ARP packets on a list of comma-separated
VLAN ranges.
Format
no ip arp inspection vlan vlan-list logging
Mode
Global Config

ip arp inspection trust

Use this command to configure an interface as trusted for Dynamic ARP Inspection.
Default
enabled
Format
ip arp inspection trust
Mode
Interface Config
ProSafe Managed Switch
Switching Commands
155