NETGEAR ProSafe GSM7224P User Manual page 396

Term Definition
Maximum
The maximum number of LSAs that can be waiting for acknowledgment at any given
Number of
time.
Retransmit
Entries
Retransmit
The highest number of LSAs that have been waiting for acknowledgment.
Entries High
Water Mark
External LSDB
The maximum number of non-default AS-external-LSAs entries that can be stored in the
Limit
link-state database.
Default Metric
Default value for redistributed routes.
Default Passive
Shows whether the interfaces are passive by default.
Setting
Default Route
Indicates whether the default routes received from other source protocols are advertised
Advertise
or not.
Always
Shows whether default routes are always advertised.
Metric
The metric for the advertised default routes. If the metric is not configured, this field is
blank.
Metric Type
Shows whether the routes are External Type 1 or External Type 2.
Number of
The number of active OSPF areas. An "active" OSPF area is an area with at least one
Active Areas
interface up.
AutoCost Ref
Shows the value of the auto-cost reference bandwidth configured on the router.
BW
Maximum Paths The maximum number of paths that OSPF can report for a given destination.
Redistributing
This field is a heading and appears only if you configure the system to take routes
learned from a non-OSPF source and advertise them to its peers.
Source
Shows source protocol/routes that are being redistributed. Possible values are static,
connected, BGP, or RIP.
Metric
The metric of the routes being redistributed.
Metric Type
Shows whether the routes are External Type 1 or External Type 2.
Tag
The decimal value attached to each external route.
Subnets
For redistributing routes into OSPF, the scope of redistribution for the specified protocol.
Distribute-List
The access list used to filter redistributed routes.
ProSafe Managed Switch
IPv6 Commands
396