NETGEAR ProSafe GSM7224P User Manual page 641

Note: To re-configure a RADIUS authentication server to use the default
UDP <port>, set the <port> parameter to 1812.
If you use the <acct> token, the command configures the IP address or hostname to use for
the RADIUS accounting server. You can only configure one accounting server. If an
accounting server is currently configured, use the "no" form of the command to remove it
from the configuration. The IP address or hostname you specify must match that of a
previously configured accounting server. If you use the optional <port> parameter, the
command configures the UDP port to use when connecting to the RADIUS accounting
server. If a <port> is already configured for the accounting server, the new <port> replaces
the previously configured <port>. The <port> must be a value in the range 0 - 65535, with
1813 being the default.
Note: To re-configure a RADIUS accounting server to use the default UDP
<port>, set the <port> parameter to 1813.
Format
radius server host {auth | acct} {<ipaddr|dnsname>} [name
<servername>] [port <0-65535>][server-type]
Mode
Global Config
Field Description
ipaddr
The IP address of the server.
dnsname
The DNS name of the server.
0-65535
The port number to use to connect to the specified RADIUS server.
servername
The alias name to identify the server.
no radius server host
Use the version of this command to delete the configured server entry from the list of
no
configured RADIUS servers. If the RADIUS authenticating server being removed is the active
server in the servers that are identified by the same server name, then the RADIUS client
selects another server for making RADIUS transactions. If the 'auth' token is used, the
previously configured RADIUS authentication server is removed from the configuration.
Similarly, if the 'acct' token is used, the previously configured RADIUS accounting server is
removed from the configuration. The <ipaddr|dnsname> parameter must match the IP
ProSafe Managed Switch
Management Commands
641